www.ka-t.org

Hey, I know this an old thread but I can't find much info on this version of safc. If any could offer insight, I'd greatly appreciate it. Just trying to get it running.I wired mine up and it barely idles. Wideband is showing 9 afr. The ecu is throwing a code for a bad maf. 850cc Injectors T28 Z32 M...

Look into the cxracing 'thick' manifold. It's the same as the original design, only made stronger with thicker metal.

You can just not use the blow off valve if you don't like it. That's what my brother did with his ebay bov. Just blocked it off. Typical tuzzio using his favorite sarcastic link.

Try Zilvia.net there are a lot of Californians there.

Thanks so much, but this was my brother's car and he decided to order an RS-Enthalpy tune. I guess he just didn't want to think about tuning

Hello everyone, I have a basic tune done for my ka-t but I am wondering if anyone has any ROMs they are willing to post up for me to look at and / or try out. My setup is as follows: s14 ka24de with automatic ecu deatschwerks 370cc injectors deatschwers dw200 fuel pump z32 maf isr rs3871 turbo (gt28...

Hello everyone, I recently purchased a 1989 240sx with a turbo single cam. The car idles very rich and dies whenever I barely touch the gas. The car came with the stock maf and injectors, and also a rom tune that the previous owner didn't know where it was from. I took the cover off of the ECU, and ...

Thanks man I'll try it out.

_______________bump

Bump. I really want to learn this.

I tried lowering my k const by 25%, but it caused the car to run lean. Setting the latency to 580 (the correct value for sr injectors) made it even leaner. The car stalled out and died. Why would the k const work fine for cruise and idle, but be too high for boost? If I set my k const for cruise and...

1. I am planning for this to be a street car, with possible occasional track use. I want to run 8psi for now, and then once everything seems reliable enough, I will shoot for more boost. 2. I left the latency stock. I read that I should use k const for cruise afr, and make small adjustments to laten...

I'll try the brake boosting thing when I get the chance. Here is my log: https://drive.google.com/open?id=0B4E7n ... GViR1kzamM

I have an isis mbc, but I can't get it to do anything really. I'm just going to stick with 8 psi for now. I don't believe I am running the feature pack either. Here is a link to the map: https://drive.google.com/open?id=0B4E7nx8fH4GDeHJlMzk2UnplWVU I will upload my log later today. It contains a sec...

Bump. Need help here guys.

Hey guys, I am tuning my ka-t on nistune and have been having trouble finding which boost levels reach which load indexes. This makes it hard for me to know when to start pulling timing / adding fuel. I'm trying to do 3/4 of a degree for each psi, but I have no way of knowing which maf reading corre...