what clutch setup are you running?

[wtfarpus]

hey i am putting together my ka-t, hoping to make mid to high 400s and I haven't decided on a clutch setup yet. any recommendations?

[tacokiller07]

white bunny setup ftw

[tacokiller07]

white bunny setup ftw

[schmauster920]

Im running a cheap D21 flywheel and clutch which should be good for about 350~

If i was in your position I would get a full faced 350z clutch. Basically a stock clutch with a little higher clamping force. That will give you smooth engagment and be able to hold 400+ for sure

[wtfarpus]

Thanks guys, would a z33 clutch bolt up properly?

[1SikS13]

i did the enjuku white bunny clutch setup. and im expecting 500 this year

[wtfarpus]

i did the enjuku white bunny clutch setup. and im expecting 500 this year

what kind of power are you making at the moment?

[bicer9]

putting in my comp. clutch white bunny set up tomorrow, we'll see how that goes lol. I dont expect to make much over 300 anytime soon though.

[beercandrifter]

ran the d21 flywheel and the z32 300zx n/a ACT HDSS clutch. held mid 400s without a sweat. and act is nice because you can purchase new pressure plates and clutch disks online if you wear them out, no need to buy a whole new clutch.