So i recently completely put everything back together with my first build
Every bolt is in the right spot down to every wire
Its a rom tune from rsenathply
1000cc id's
Aeromotive fpr
255 walboro
Built motor:
Port polished
Bored.20 over
Brian crower stage 2 cams 264 264
Supertech valves and springs
Supertech pistons 8:4:1
Supertech retainers
Clevite bearings
Eagle H-beam rods
Cosmetic gasket
Arp studs all around
Balanced and polished the stock crank
Turbo:
Precision turbo 5130
Tomei outlet
Megan downpipe
Isis manifold
Isis blastpipes
Excessive mani
Q45 tb
Nissan quest alternator
Z32 maf
I just re-did the timing second time now
I just cant it to start up
Ive switched out the distributor with a spare
Im getting fuel but no spark
Ive even replaced all fuses
Im at a loss, it just cranks
Start up issues
Re: Start up issues
Make sure you're getting power to the coil, ohm it out and make sure it's ok. Check for continuity between the chassis and grounds on the head and those for the ignition coil. Pull up a picture/diagram of your engine harness and make sure you account for all grounds that go to the head.
Unfortunately there are quite a few factors that can create a no-spark condition but it can be overcome
Unfortunately there are quite a few factors that can create a no-spark condition but it can be overcome
R.I.P. 1990 Red Hatch - DOHC 5 speed // CP 9:1 - Eagle Rods - Clevite - ARP // Holset HX35 - 20psi daily - MSPNP2
8-bit wrote:You could spend your life building a ladder to the moon, or work for 5 years to pay for a trip.