Page 1 of 1
First KA-T Dyno ever...
Posted: Wed Mar 07, 2012 12:06 am
by croatian_sensation
Hello everyone,
Finally went KA-T...this is my first car and first build...pleased to share it with all of you!
Build:
- Stock Motor
- Precision 3231E Turbo .63a/r
- Deatschwerks 550cc Fuel Injectors
- JGS Turbo Manifold
- Haltech Platinum Sprint 500
Now for numbers...
246hp, 244lbs. torque @6psi
Tuned by Bill at Independent Speed Shop. Sorry only have a crap picture because the place we dyno'd at had a broken printer...will post better quality graph soon!
Posted: Wed Mar 07, 2012 5:29 am
by supakat
Posted: Wed Mar 07, 2012 8:03 am
by DC47A
Congratulations on the first dyno experience. Not bad numbers for that turbo and 6psi.
Posted: Wed Mar 07, 2012 11:02 am
by DrEaMeR_VaNg
Congrats!
Great #'s for 6psi!
Posted: Wed Mar 07, 2012 11:50 am
by joshpntbl07
good job. now where is that boost controller?
Posted: Wed Mar 07, 2012 12:15 pm
by Kamilitaryman
Wow, that's not bad at all for 6psi!
Congrats man, I can't freakin wait till I see what mine puts down.
Posted: Wed Mar 07, 2012 9:02 pm
by croatian_sensation
Thanks guys. The reason we stuck to 6psi for now is because this is my daily driver as well...but hoping to get a little more out of it for the summer though.
Appreciate all the positive feedback!
Posted: Thu Mar 08, 2012 1:39 am
by broxma
Was it a Dyno Dynamics brake dyno? Did he add the obligatory 15% "Dynojet correction factor" or is that an uncorrected number? A good number either way, but if that's uncorrected, it'll probably do 280 on a Dynojet by way of comparison.
/brox
Posted: Fri Mar 09, 2012 11:18 am
by croatian_sensation
Yes it was a Dyno Dynamics dyno...and there was no correction made...my tuner told me on other dynos it may read around 270-280 like you stated. Thank you for the feedback!
Posted: Fri Dec 28, 2012 2:12 pm
by mechavore884
hey what downpipe are you using and waste gate?.....lol funny Im doing a complete overhaul and THIS IS dam near SPOT ON what I was planning to do (just enthalpy instead)
Posted: Tue Jan 15, 2013 11:37 am
by niceguy
Nice numbers! You have a build thread yet?
Posted: Thu Feb 07, 2013 12:50 pm
by croatian_sensation
I am using a custom 3" downpipe and a Tial 38mm wastegate.
Unfortunately, I blew the motor. I'm doing a fully built motor now, should be done in a bit and I should have it dyno'd sometime in March/April.
Hoping for around 350 this time then maybe 400-500 after I upgrade injectors, clutch, and trans.