I have an Enthalpy tuned ECU for my set up (t3t4, 8.1:1, 550cc, 264 cams). I was wondering if it would do any harm to the engine/ecu if I piggybacked it with the FIC-6 I happen to have laying around unused for fine tuning or future engine/setup changes.
Any thoughts on this?
Enthalpy ROM + AEM FIC-6?
- hotbox240
- Knows Some Stuff About 240's!
- Posts: 480
- Joined: Sun Sep 25, 2005 7:43 pm
- Location: Abbotsford, B.C
Re: Enthalpy ROM + AEM FIC-6?
I'm using an Safc II with my EPROM tune. Works good to fine tune AFRs.
12.43 @ 115.06 - 05/2010
12.28 @ 117.61 - 08/2016
12.28 @ 117.61 - 08/2016