Single cam on the street...

NA or Forced Induction 240 videos ONLY here.
Post Reply
User avatar
Jordan Gladman
Belongs To The TOP CONTRIBUTING MEMBERS!
Posts: 3254
Joined: Tue Jul 20, 2004 11:14 pm
Location: Abbotsford, BC

Single cam on the street...

Post by Jordan Gladman »

Couple pulls. (ignore the wideband, i had just blown the factory 02 out of the bung when I hit rev limit so I was sucking wind)

http://www.streetfire.net/video/sohc-ka24et_2056867.htm

http://www.streetfire.net/video/sohc-ka24et_2056869.htm

http://www.streetfire.net/video/sohc-ka24et_2056873.htm


Not bad for 1 hand on the camera and wheel at the same time! :shock:
WWW.GLADFAB.COM SOHC Turbo Manifolds
pwjm
240sx Wannabe
Posts: 164
Joined: Mon Sep 14, 2009 9:09 pm
Location: Kelowna, BC

Post by pwjm »

:bowdown: :bowdown: :bowdown:
Niclas_AB
Knows Some Stuff About 240's!
Posts: 365
Joined: Tue Sep 05, 2006 10:29 am
Location: SWEDEN

Post by Niclas_AB »

Nice! :D What boost are you runing and what power do you think you're at? is that third and 4th gear in the first vid? You seem to have a slightly different gearing than me :)
User avatar
Jordan Gladman
Belongs To The TOP CONTRIBUTING MEMBERS!
Posts: 3254
Joined: Tue Jul 20, 2004 11:14 pm
Location: Abbotsford, BC

Post by Jordan Gladman »

Its 2nd/3rd gear.

These vids were with my first cam shaft, the cam i'm running now is quite a bit more aggressive and opened up the top end like a can of worms. I was running 25psi on my JDM sport knock off GT35, but I've switched to the T3 super 60-1. I'll probably run it at 20psi and hoping to be just over 400whp.

I would imagine our gearing is the same, I just have a different tach. I dont usually rev my SOHC much past 7000.
WWW.GLADFAB.COM SOHC Turbo Manifolds
Niclas_AB
Knows Some Stuff About 240's!
Posts: 365
Joined: Tue Sep 05, 2006 10:29 am
Location: SWEDEN

Post by Niclas_AB »

Ah, ok. I'm running a manual s14 diff with a gear ratio of 3.692, our gearboxes are probably the same thou. But when I look at your speedo your doing about 140mph in third gear :? or wait, are the big numbers on your speedo km/h and the small ones that you really can't se mph?

Either way, that is one cool s13 sohc, love your mustang rims! wish that I could find a way to ship them cheap to Sweden :roll:
User avatar
Jordan Gladman
Belongs To The TOP CONTRIBUTING MEMBERS!
Posts: 3254
Joined: Tue Jul 20, 2004 11:14 pm
Location: Abbotsford, BC

Post by Jordan Gladman »

Take a flight over... You could probably get 2 in each suit case.

My speedo is KM/H - Canada. :wink:
WWW.GLADFAB.COM SOHC Turbo Manifolds
s13grady
Dont Question My Nissan Knowledge
Posts: 817
Joined: Sun Sep 05, 2004 12:31 pm
Location: Jersey

Post by s13grady »

impressive once again.
92 s13 ka24det sc61 project.
street trim sleeper
Niclas_AB
Knows Some Stuff About 240's!
Posts: 365
Joined: Tue Sep 05, 2006 10:29 am
Location: SWEDEN

Post by Niclas_AB »

ah, then it makes sense :lol:
Post Reply