I have been porting head for customers for a while now figured I would show some work
will have the intake side done in a day or two to show
Cylinder Head Porting
-
- Knows Some Stuff About 240's!
- Posts: 338
- Joined: Tue Nov 08, 2011 8:22 pm
- Location: Kankakee IL
-
- Knows Some Stuff About 240's!
- Posts: 448
- Joined: Sat Oct 08, 2005 2:13 pm
Re: Cylinder Head Porting
Not bad. You damaged the flange though.
-
- Knows Some Stuff About 240's!
- Posts: 338
- Joined: Tue Nov 08, 2011 8:22 pm
- Location: Kankakee IL
Re: Cylinder Head Porting
I assume he's talking about the gouges/scratches on the flange (the flat part) that mates with the exhaust manifold.
You can see it in every picture
You can see it in every picture
R.I.P. 1990 Red Hatch - DOHC 5 speed // CP 9:1 - Eagle Rods - Clevite - ARP // Holset HX35 - 20psi daily - MSPNP2
8-bit wrote:You could spend your life building a ladder to the moon, or work for 5 years to pay for a trip.
- sdaigle240
- Belongs To The TOP CONTRIBUTING MEMBERS!
- Posts: 4670
- Joined: Wed Oct 17, 2007 9:53 am
- Location: CONN.
Re: Cylinder Head Porting
just eye ball or u measure the volume? i was afraid to take out too much for evenness. i pressy much just gasket matched.
airman wrote:I'm all about spreadsheets. Bitches love spreadsheets.
schmauster920 wrote:I shall cast my own pistons in the sands of time, then forge them in the depths of hell.. as funds allow
hy35 18psi Build Thread: viewtopic.php?t=38784
RIP MJL best friend of 20 years and the man who showed me 240s
-
- Knows Some Stuff About 240's!
- Posts: 338
- Joined: Tue Nov 08, 2011 8:22 pm
- Location: Kankakee IL
Re: Cylinder Head Porting
I have a flow bench and there is a lot of room in these heads for reaming out.... I usually make it completely symmetrical all around all the casting marks in these heads will come out in the bowl and the sides of each exhaust and intake hole plenty of room to correct this. And yea there are little nicks here and there on the flange but that will all be decked after it is done should only take a pass or 2 to correct that.
Cam
Re: Cylinder Head Porting
Looks good.