DIY autotune

Advanced discussion of improving KA-T components

DIY autotune

Postby Newkid99 » Fri Apr 21, 2017 12:04 pm

Hi guys I am new to the forum but I've done lots of research and reading on here and never made an account until now. Recently as my build slowly comes together it has come time to decide on what tuning system to use. Originally I planned on ordering an ecu from enthalpy but to have more reliability and tuning ability I wanted to go with megasquirt. I also like that I can run a map sensor instead of a z32 maf sensor. My question is if anyone has built their own from DIY autoune? Here is a link to their page:
https://www.diyautotune.com/support/tec ... our-240sx/
I was also wondering if anyone has used this on an s14 ka with the coil inside of the distributor? It seems like all of the diagrams on this page tell me it is only meant for s13 models with an external coil. Any help is appreciated.
Newkid99
NooB
 
Posts: 2
Joined: Fri Apr 21, 2017 11:50 am

Re: DIY autotune

Postby BigLoukaT » Sat May 06, 2017 11:31 am

short answer is yes - there have been a bunch of people that have built/bought megasquirt setups especially with the creation of the PNP kits. What version are you looking into? If the S14 has a power transducer for the coil, then any of the PNP setups on microsquirt will run it. A lot of the talk about the external coil setups were because the megasquirt would control the coil via an onboard power transducer, instead of using the stock one, however that strategy has been somewhat passed by as we can control the existing transducer.

Personally, I have built a DIYPNP with sequential injection and it is my favorite thing about my car at this point. Best decision I made and never looked back.
1990 S13
Boosted single slammer
MS DIYPNP

npx from 240sxforums wrote:i figure from my very limited knowledge about the 240 and under the hood about cars in general i would follow the sr20det trend.
User avatar
BigLoukaT
Dont Question My Nissan Knowledge
 
Posts: 879
Joined: Sun Jul 23, 2006 11:03 am
Location: MA

Re: DIY autotune

Postby Newkid99 » Fri Jan 11, 2019 2:20 pm

BigLoukaT wrote:short answer is yes - there have been a bunch of people that have built/bought megasquirt setups especially with the creation of the PNP kits. What version are you looking into? If the S14 has a power transducer for the coil, then any of the PNP setups on microsquirt will run it. A lot of the talk about the external coil setups were because the megasquirt would control the coil via an onboard power transducer, instead of using the stock one, however that strategy has been somewhat passed by as we can control the existing transducer.

Personally, I have built a DIYPNP with sequential injection and it is my favorite thing about my car at this point. Best decision I made and never looked back.

So i bought a diy autotune msx3 kit and I have it all built but had some questions still. Is there a guide on how to do the sequential injection? Also I was pretty sure the set up for the idle valve was the 2 wire pwm but I dont know? What jumpers do I need to solder in for a ka-t? Emailing diy autotune now to ask if they can send me a list of jumpers, but I would like to do a write up once I have it done and working.
Newkid99
NooB
 
Posts: 2
Joined: Fri Apr 21, 2017 11:50 am


Return to KA-T Tech. Advanced

Who is online

Users browsing this forum: No registered users and 58 guests