Page 1 of 1

Would You run these pistons???

Posted: Mon Dec 05, 2022 3:30 pm
by 505240
Hi all! I have a chance to drop these CPs into a block I'm freshining up, looks like there was a littl bit of piston slap going on. Anyone pulled something similar and run them with no issues? Thanks in advance for any insight and info!

Re: Would You run these pistons???

Posted: Sat Dec 17, 2022 8:23 am
by p00t
Can you get a good measurement of the diameter where the scuff is the worst vs rotated to an un-scuffed area right next to it? I would see how many thousandths have worn away. You can easily throw those numbers into an email to CP. But I think they usually recommend no more than 2-3 thousandths.