ARP main studs last 2 are too short

Advanced discussion of improving KA-T components
Post Reply
Knows Some Stuff About 240's!
Posts: 499
Joined: Wed Aug 29, 2007 2:41 am

ARP main studs last 2 are too short

Post by importdude »

There are 3 longer studs.
the last 2 toward the flywheel are barely showing any threads past the nut.

all studs were hand screwed into block . All bottomed out the block, since the threads were cleaned.

Can i safely just back up the studs alittle for the last 2 studs?

Someone suggested just backing out a few turns on the stud and locktite it

Has anyone ran into this issue?
Post Reply