DIY steering knuckles
-
- NooB
- Posts: 2
- Joined: Thu Jan 30, 2014 4:44 pm
DIY steering knuckles
Has any one done a set before if so how did you go about it
- eazye2000
- Encyclopedia-Nissan
- Posts: 1358
- Joined: Tue Jan 16, 2007 4:32 am
- Location: Inverness, FL
- Contact:
Re: DIY steering knuckles
I think there is a thread in this section. I had talked about this a while back I think also.
I have an extra set I've been wanting to play with. I'll be home tonight and I'll link/reference some material if I can find it.
I have an extra set I've been wanting to play with. I'll be home tonight and I'll link/reference some material if I can find it.
-
- NooB
- Posts: 2
- Joined: Thu Jan 30, 2014 4:44 pm
Re: DIY steering knuckles
I have every thing to do it , also the knowledge on welding cast steel I'm really just looking for the measurements on how much to cut
Re: DIY steering knuckles
better late than never..
I have a set its been a while but iirc I removed an inch. I cut like this || I should have notched each side and lowered the rod location. mine were also reinforced they have been good for several events and a couple test session.
I have a set its been a while but iirc I removed an inch. I cut like this || I should have notched each side and lowered the rod location. mine were also reinforced they have been good for several events and a couple test session.
- sdaigle240
- Belongs To The TOP CONTRIBUTING MEMBERS!
- Posts: 4670
- Joined: Wed Oct 17, 2007 9:53 am
- Location: CONN.
Re: DIY steering knuckles
driftworks forums. extensive threads about this with even measurements on some.
airman wrote:I'm all about spreadsheets. Bitches love spreadsheets.
schmauster920 wrote:I shall cast my own pistons in the sands of time, then forge them in the depths of hell.. as funds allow
hy35 18psi Build Thread: viewtopic.php?t=38784
RIP MJL best friend of 20 years and the man who showed me 240s