My new motor being broken in properly
-
- KA-T.org Featured Ride
- Posts: 890
- Joined: Fri Mar 26, 2004 12:55 am
- Location: Denton, TX
- Contact:
My new motor being broken in properly
843whp @ 40psi
761/596 Tq 33psi 6766
http://www.enginerebuild.net
"Anyone can make power but how long can you make it last?"
761/596 Tq 33psi 6766
http://www.enginerebuild.net
"Anyone can make power but how long can you make it last?"
Re: My new motor being broken in properly
Awesome man! What's new for the setup?
-
- KA-T.org Featured Ride
- Posts: 890
- Joined: Fri Mar 26, 2004 12:55 am
- Location: Denton, TX
- Contact:
Re: My new motor being broken in properly
Just a good set of uncracked Wiseco pistons and Ken Bell Boost a spark. oh yea, and a fresh paint job
I broke another stock tranny the night of that vid. I'm currently in the process of Z32 trans swap along with a higher gear ratio to try to assist with some of that spinning problem I have.
I broke another stock tranny the night of that vid. I'm currently in the process of Z32 trans swap along with a higher gear ratio to try to assist with some of that spinning problem I have.
843whp @ 40psi
761/596 Tq 33psi 6766
http://www.enginerebuild.net
"Anyone can make power but how long can you make it last?"
761/596 Tq 33psi 6766
http://www.enginerebuild.net
"Anyone can make power but how long can you make it last?"
Re: My new motor being broken in properly
More vids or it didn't happen!
Re: My new motor being broken in properly
Nice, Wiseco and Boost-a-spark FTW!! Let's see some pics of that shiny paintjob.
P.S. That's how you drive...
P.P.S. That's how you drive...
P.S. That's how you drive...
P.P.S. That's how you drive...
Wiseco/Eagle, JWT S1 cams, BC valve springs, PT5857, ID1700 injectors, SR20DET ECU w/ Nismotronic, COP conversion with LS ignition coils, etc, etc...
--> YouTube channel --> my build thread
--> YouTube channel --> my build thread